arm64: dts: rockchip: enable second PCIe controller on
From: Heiko Stuebner <heiko@...> Date: Tue, 9 Jul 2024 00:03:25 +0200
Commit-Message
The TS433 uses both pcie controllers for sata and the 2nd network interface. Set the needed data-lanes in the pcie3 phy and enable the second pcie controller, as well as remove the bifurcation comment. Tested-by: Uwe Kleine-König <ukleinek@...> Signed-off-by: Heiko Stuebner <heiko@...>
Patch-Comment
arch/arm64/boot/dts/rockchip/rk3568-qnap-ts433.dts | 10 +++++++++- 1 file changed, 9 insertions(+), 1 deletion(-)
Statistics
- 9 lines added
- 1 lines removed
Changes
-------------- arch/arm64/boot/dts/rockchip/rk3568-qnap-ts433.dts --------------
index 07b4f095d766a..9bf9c3b65ca31 100644
@@ -78,17 +78,25 @@ rgmii_phy0: ethernet-phy@0 {
};
&pcie30phy {
+ data-lanes = <1 2>;
status = "okay";
};
/* Connected to a JMicron AHCI SATA controller */
&pcie3x1 {
reset-gpios = <&gpio0 RK_PC7 GPIO_ACTIVE_HIGH>;
vpcie3v3-supply = <&vcc3v3_pcie>;
status = "okay";
};
+/* Connected to the 2.5G NIC for the upper network jack */
+&pcie3x2 {
+ num-lanes = <1>;
+ reset-gpios = <&gpio2 RK_PD6 GPIO_ACTIVE_HIGH>;
+ vpcie3v3-supply = <&vcc3v3_pcie>;
+ status = "okay";
+};
+
&sdhci {
bus-width = <8>;
max-frequency = <200000000>;