This algorithm will try 1 degree increments, since there's no way to tell
what resolution the underlying phase code uses. As an added bonus, doing
many tunings yields better results since some tests are run more than once
(ex: if the underlying driver uses 45 degree increments, the tuning code
will try the same angle more than once).
It will then construct a list of good phase ranges (even ranges that cross
360/0), will pick the biggest range then it will set the sample_clk to the
middle of that range.
We do not touch ciu_drive (and by extension define default-drive-phase).
Drive phase is mostly used to define minimum hold times, while one could
write some code to determine what phase meets the minimum hold time (ex 10
degrees) this will not work with the current clock phase framework (which
floors angles, so we'll get 0 deg, and there's no way to know what
resolution the floors happen at). We assume that the default drive angles
set by the hardware are good enough.
If a device has device specific code (like exynos) then that will still
take precedence, otherwise this new code will execute. If the device wants
to tune, but has no sample_clk defined we'll return EIO with an error
message.
Signed-off-by: Alexandru M Stan <amstan@...>
Signed-off-by: Heiko Stuebner <heiko@...>
Acked-by: Jaehoon Chung <jh80.chung@...>
drivers/mmc/host/dw_mmc-rockchip.c | 162 +++++++++++++++++++++++++++++++++++++
1 file changed, 162 insertions(+)
@@ -13,12 +13,19 @@
#include <linux/mmc/host.h>
#include <linux/mmc/dw_mmc.h>
#include <linux/of_address.h>
+#include <linux/slab.h>
#include "dw_mmc.h"
#include "dw_mmc-pltfm.h"
#define RK3288_CLKGEN_DIV 2
+struct dw_mci_rockchip_priv_data {
+ struct clk *drv_clk;
+ struct clk *sample_clk;
+ int default_sample_phase;
+};
+
static void dw_mci_rockchip_prepare_command(struct dw_mci *host, u32 *cmdr)
{
*cmdr |= SDMMC_CMD_USE_HOLD_REG;
@@ -33,6 +40,7 @@ static int dw_mci_rk3288_setup_clock(struct dw_mci *host)
static void dw_mci_rk3288_set_ios(struct dw_mci *host, struct mmc_ios *ios)
{
+ struct dw_mci_rockchip_priv_data *priv = host->priv;
int ret;
unsigned int cclkin;
u32 bus_hz;
@@ -66,6 +74,158 @@ static void dw_mci_rk3288_set_ios(struct dw_mci *host, struct mmc_ios *ios)
/* force dw_mci_setup_bus() */
host->current_speed = 0;
}
+
+ /* Make sure we use phases which we can enumerate with */
+ if (!IS_ERR(priv->sample_clk))
+ clk_set_phase(priv->sample_clk, priv->default_sample_phase);
+}
+
+#define NUM_PHASES 360
+#define TUNING_ITERATION_TO_PHASE(i) (DIV_ROUND_UP((i) * 360, NUM_PHASES))
+
+static int dw_mci_rk3288_execute_tuning(struct dw_mci_slot *slot)
+{
+ struct dw_mci *host = slot->host;
+ struct dw_mci_rockchip_priv_data *priv = host->priv;
+ struct mmc_host *mmc = slot->mmc;
+ int ret = 0;
+ int i;
+ bool v, prev_v = 0, first_v;
+ struct range_t {
+ int start;
+ int end; /* inclusive */
+ };
+ struct range_t *ranges;
+ unsigned int range_count = 0;
+ int longest_range_len = -1;
+ int longest_range = -1;
+ int middle_phase;
+
+ if (IS_ERR(priv->sample_clk)) {
+ dev_err(host->dev, "Tuning clock (sample_clk) not defined.\n");
+ return -EIO;
+ }
+
+ ranges = kmalloc_array(NUM_PHASES / 2 + 1, sizeof(*ranges), GFP_KERNEL);
+ if (!ranges)
+ return -ENOMEM;
+
+ /* Try each phase and extract good ranges */
+ for (i = 0; i < NUM_PHASES; ) {
+ clk_set_phase(priv->sample_clk, TUNING_ITERATION_TO_PHASE(i));
+
+ v = !mmc_send_tuning(mmc);
+
+ if (i == 0)
+ first_v = v;
+
+ if ((!prev_v) && v) {
+ range_count++;
+ ranges[range_count-1].start = i;
+ }
+ if (v) {
+ ranges[range_count-1].end = i;
+ i++;
+ } else if (i == NUM_PHASES - 1) {
+ /* No extra skipping rules if we're at the end */
+ i++;
+ } else {
+ /*
+ * No need to check too close to an invalid
+ * one since testing bad phases is slow. Skip
+ * 20 degrees.
+ */
+ i += DIV_ROUND_UP(20 * NUM_PHASES, 360);
+
+ /* Always test the last one */
+ if (i >= NUM_PHASES)
+ i = NUM_PHASES - 1;
+ }
+
+ prev_v = v;
+ }
+
+ if (range_count == 0) {
+ dev_warn(host->dev, "All phases bad!");
+ ret = -EIO;
+ goto free;
+ }
+
+ /* wrap around case, merge the end points */
+ if ((range_count > 1) && first_v && v) {
+ ranges[0].start = ranges[range_count-1].start;
+ range_count--;
+ }
+
+ if (ranges[0].start == 0 && ranges[0].end == NUM_PHASES - 1) {
+ clk_set_phase(priv->sample_clk, priv->default_sample_phase);
+ dev_info(host->dev, "All phases work, using default phase %d.",
+ priv->default_sample_phase);
+ goto free;
+ }
+
+ /* Find the longest range */
+ for (i = 0; i < range_count; i++) {
+ int len = (ranges[i].end - ranges[i].start + 1);
+
+ if (len < 0)
+ len += NUM_PHASES;
+
+ if (longest_range_len < len) {
+ longest_range_len = len;
+ longest_range = i;
+ }
+
+ dev_dbg(host->dev, "Good phase range %d-%d (%d len)\n",
+ TUNING_ITERATION_TO_PHASE(ranges[i].start),
+ TUNING_ITERATION_TO_PHASE(ranges[i].end),
+ len
+ );
+ }
+
+ dev_dbg(host->dev, "Best phase range %d-%d (%d len)\n",
+ TUNING_ITERATION_TO_PHASE(ranges[longest_range].start),
+ TUNING_ITERATION_TO_PHASE(ranges[longest_range].end),
+ longest_range_len
+ );
+
+ middle_phase = ranges[longest_range].start + longest_range_len / 2;
+ middle_phase %= NUM_PHASES;
+ dev_info(host->dev, "Successfully tuned phase to %d\n",
+ TUNING_ITERATION_TO_PHASE(middle_phase));
+
+ clk_set_phase(priv->sample_clk,
+ TUNING_ITERATION_TO_PHASE(middle_phase));
+
+free:
+ kfree(ranges);
+ return ret;
+}
+
+static int dw_mci_rk3288_parse_dt(struct dw_mci *host)
+{
+ struct device_node *np = host->dev->of_node;
+ struct dw_mci_rockchip_priv_data *priv;
+
+ priv = devm_kzalloc(host->dev, sizeof(*priv), GFP_KERNEL);
+ if (!priv)
+ return -ENOMEM;
+
+ if (of_property_read_u32(np, "rockchip,default-sample-phase",
+ &priv->default_sample_phase))
+ priv->default_sample_phase = 0;
+
+ priv->drv_clk = devm_clk_get(host->dev, "ciu-drive");
+ if (IS_ERR(priv->drv_clk))
+ dev_dbg(host->dev, "ciu_drv not available\n");
+
+ priv->sample_clk = devm_clk_get(host->dev, "ciu-sample");
+ if (IS_ERR(priv->sample_clk))
+ dev_dbg(host->dev, "ciu_sample not available\n");
+
+ host->priv = priv;
+
+ return 0;
}
static int dw_mci_rockchip_init(struct dw_mci *host)
@@ -95,6 +255,8 @@ static const struct dw_mci_drv_data rk3288_drv_data = {
.caps = dw_mci_rk3288_dwmmc_caps,
.prepare_command = dw_mci_rockchip_prepare_command,
.set_ios = dw_mci_rk3288_set_ios,
+ .execute_tuning = dw_mci_rk3288_execute_tuning,
+ .parse_dt = dw_mci_rk3288_parse_dt,
.setup_clock = dw_mci_rk3288_setup_clock,
.init = dw_mci_rockchip_init,
};