Also known as the Asus Chromebook Flip.
Signed-off-by: Alexandru M Stan <amstan@...>
Signed-off-by: Heiko Stuebner <heiko@...>
Documentation/devicetree/bindings/arm/rockchip.txt | 7 +
arch/arm/boot/dts/Makefile | 1 +
arch/arm/boot/dts/rk3288-veyron-minnie.dts | 253 +++++++++++++++++++++
3 files changed, 261 insertions(+)
create mode 100644 arch/arm/boot/dts/rk3288-veyron-minnie.dts
@@ -38,6 +38,13 @@ Rockchip platforms device tree bindings
"google,veyron-jerry-rev3", "google,veyron-jerry",
"google,veyron", "rockchip,rk3288";
+- Google Minnie (Asus Chromebook Flip C100P):
+ Required root node properties:
+ - compatible = "google,veyron-minnie-rev4", "google,veyron-minnie-rev3",
+ "google,veyron-minnie-rev2", "google,veyron-minnie-rev1",
+ "google,veyron-minnie-rev0", "google,veyron-minnie",
+ "google,veyron", "rockchip,rk3288";
+
- Google Pinky (dev-board):
Required root node properties:
- compatible = "google,veyron-pinky-rev2", "google,veyron-pinky",
@@ -491,6 +491,7 @@ dtb-$(CONFIG_ARCH_ROCKCHIP) += \
rk3288-firefly.dtb \
rk3288-r89.dtb \
rk3288-veyron-jerry.dtb \
+ rk3288-veyron-minnie.dtb \
rk3288-veyron-pinky.dtb \
rk3288-veyron-speedy.dtb
dtb-$(CONFIG_ARCH_S3C24XX) += \
@@ -0,0 +1,253 @@
+/*
+ * Google Veyron Minnie Rev 0+ board device tree source
+ *
+ * Copyright 2015 Google, Inc
+ *
+ * This file is dual-licensed: you can use it either under the terms
+ * of the GPL or the X11 license, at your option. Note that this dual
+ * licensing only applies to this file, and not this project as a
+ * whole.
+ *
+ * a) This file is free software; you can redistribute it and/or
+ * modify it under the terms of the GNU General Public License as
+ * published by the Free Software Foundation; either version 2 of the
+ * License, or (at your option) any later version.
+ *
+ * This file is distributed in the hope that it will be useful,
+ * but WITHOUT ANY WARRANTY; without even the implied warranty of
+ * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
+ * GNU General Public License for more details.
+ *
+ * Or, alternatively,
+ *
+ * b) Permission is hereby granted, free of charge, to any person
+ * obtaining a copy of this software and associated documentation
+ * files (the "Software"), to deal in the Software without
+ * restriction, including without limitation the rights to use,
+ * copy, modify, merge, publish, distribute, sublicense, and/or
+ * sell copies of the Software, and to permit persons to whom the
+ * Software is furnished to do so, subject to the following
+ * conditions:
+ *
+ * The above copyright notice and this permission notice shall be
+ * included in all copies or substantial portions of the Software.
+ *
+ * THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND,
+ * EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES
+ * OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND
+ * NONINFRINGEMENT. IN NO EVENT SHALL THE AUTHORS OR COPYRIGHT
+ * HOLDERS BE LIABLE FOR ANY CLAIM, DAMAGES OR OTHER LIABILITY,
+ * WHETHER IN AN ACTION OF CONTRACT, TORT OR OTHERWISE, ARISING
+ * FROM, OUT OF OR IN CONNECTION WITH THE SOFTWARE OR THE USE OR
+ * OTHER DEALINGS IN THE SOFTWARE.
+ */
+
+/dts-v1/;
+#include "rk3288-veyron-chromebook.dtsi"
+
+/ {
+ model = "Google Minnie";
+ compatible = "google,veyron-minnie-rev4", "google,veyron-minnie-rev3",
+ "google,veyron-minnie-rev2", "google,veyron-minnie-rev1",
+ "google,veyron-minnie-rev0", "google,veyron-minnie",
+ "google,veyron", "rockchip,rk3288";
+
+ backlight_regulator: backlight-regulator {
+ compatible = "regulator-fixed";
+ enable-active-high;
+ gpio = <&gpio2 12 GPIO_ACTIVE_HIGH>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&bl_pwr_en>;
+ regulator-name = "backlight_regulator";
+ vin-supply = <&vcc33_sys>;
+ startup-delay-us = <15000>;
+ };
+
+ panel_regulator: panel-regulator {
+ compatible = "regulator-fixed";
+ enable-active-high;
+ gpio = <&gpio7 14 GPIO_ACTIVE_HIGH>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&lcd_enable_h>;
+ regulator-name = "panel_regulator";
+ vin-supply = <&vcc33_sys>;
+ };
+
+ vcc18_lcd: vcc18-lcd {
+ compatible = "regulator-fixed";
+ enable-active-high;
+ gpio = <&gpio2 13 GPIO_ACTIVE_HIGH>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&avdd_1v8_disp_en>;
+ regulator-name = "vcc18_lcd";
+ regulator-always-on;
+ regulator-boot-on;
+ vin-supply = <&vcc18_wl>;
+ };
+};
+
+&gpio_keys {
+ pinctrl-0 = <&pwr_key_l &ap_lid_int_l &volum_down_l &volum_up_l>;
+
+ volum_down {
+ label = "Volum_down";
+ gpios = <&gpio5 11 GPIO_ACTIVE_LOW>;
+ linux,code = <KEY_VOLUMEDOWN>;
+ debounce-interval = <100>;
+ };
+
+ volum_up {
+ label = "Volum_up";
+ gpios = <&gpio5 10 GPIO_ACTIVE_LOW>;
+ linux,code = <KEY_VOLUMEUP>;
+ debounce-interval = <100>;
+ };
+};
+
+&i2c_tunnel {
+ battery: bq27500@55 {
+ compatible = "ti,bq27500";
+ reg = <0x55>;
+ };
+};
+
+&i2c3 {
+ status = "okay";
+
+ /*
+ * Touchscreen pin control is shared between Atmel and Elan devices,
+ * so we have to pull it up to the bus level.
+ */
+ pinctrl-names = "default";
+ pinctrl-0 = <&i2c3_xfer &touch_int &touch_rst>;
+
+ clock-frequency = <400000>;
+ i2c-scl-falling-time-ns = <50>;
+ i2c-scl-rising-time-ns = <300>;
+
+ touchscreen@10 {
+ compatible = "elan,ekth3500";
+ reg = <0x10>;
+ interrupt-parent = <&gpio2>;
+ interrupts = <14 IRQ_TYPE_EDGE_FALLING>;
+ reset-gpios = <&gpio2 15 GPIO_ACTIVE_LOW>;
+ vcc33-supply = <&vcc33_touch>;
+ vccio-supply = <&vcc33_touch>;
+ };
+
+ touchscreen@4a {
+ compatible = "atmel,atmel_mxt_ts";
+ reg = <0x4a>;
+ atmel,reset-gpios = <&gpio2 15 GPIO_ACTIVE_LOW>;
+ avdd-supply = <&vcc5v_touch>;
+ interrupt-parent = <&gpio2>;
+ interrupts = <14 IRQ_TYPE_EDGE_FALLING>;
+ vdd-supply = <&vcc33_touch>;
+ };
+};
+
+&rk808 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&pmic_int_l &dvs_1 &dvs_2>;
+
+ regulators {
+ vcc33_touch: LDO_REG2 {
+ regulator-min-microvolt = <3300000>;
+ regulator-max-microvolt = <3300000>;
+ regulator-name = "vcc33_touch";
+ regulator-suspend-mem-disabled;
+ };
+
+ vcc5v_touch: SWITCH_REG2 {
+ regulator-name = "vcc5v_touch";
+ regulator-suspend-mem-disabled;
+ };
+ };
+};
+
+&sdmmc {
+ disable-wp;
+ pinctrl-names = "default";
+ pinctrl-0 = <&sdmmc_clk &sdmmc_cmd &sdmmc_cd_disabled &sdmmc_cd_gpio
+ &sdmmc_bus4>;
+};
+
+&vcc_5v {
+ enable-active-high;
+ gpio = <&gpio7 21 GPIO_ACTIVE_HIGH>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&drv_5v>;
+};
+
+&vcc50_hdmi {
+ enable-active-high;
+ gpio = <&gpio5 19 GPIO_ACTIVE_HIGH>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&vcc50_hdmi_en>;
+};
+
+&pinctrl {
+ backlight {
+ bl_pwr_en: bl_pwr_en {
+ rockchip,pins = <2 12 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+ };
+
+ buck-5v {
+ drv_5v: drv-5v {
+ rockchip,pins = <7 21 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+ };
+
+ buttons {
+ volum_down_l: volum-down-l {
+ rockchip,pins = <5 11 RK_FUNC_GPIO &pcfg_pull_up>;
+ };
+
+ volum_up_l: volum-up-l {
+ rockchip,pins = <5 10 RK_FUNC_GPIO &pcfg_pull_up>;
+ };
+ };
+
+ hdmi {
+ vcc50_hdmi_en: vcc50-hdmi-en {
+ rockchip,pins = <5 19 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+ };
+
+ lcd {
+ lcd_enable_h: lcd-en {
+ rockchip,pins = <7 14 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+
+ avdd_1v8_disp_en: avdd-1v8-disp-en {
+ rockchip,pins = <2 13 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+ };
+
+ pmic {
+ dvs_1: dvs-1 {
+ rockchip,pins = <7 12 RK_FUNC_GPIO &pcfg_pull_down>;
+ };
+
+ dvs_2: dvs-2 {
+ rockchip,pins = <7 15 RK_FUNC_GPIO &pcfg_pull_down>;
+ };
+ };
+
+ prochot {
+ gpio_prochot: gpio-prochot {
+ rockchip,pins = <2 8 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+ };
+
+ touchscreen {
+ touch_int: touch-int {
+ rockchip,pins = <2 14 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+
+ touch_rst: touch-rst {
+ rockchip,pins = <2 15 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+ };
+};